The EDID on the 3D Encoder - which is the first device in the chain to the source – is set to be recognized as a 3D-ready display. Some companies such as Atlona have overcome this challenge by memorizing or adding custom EDID on the switch side. Normally, once a source sees a 2D display in a single or shared use, the 3D functionality is turned off.
With Just Add Power’s solution, crosstalk was less bothersome than it tends to be with traditional 3D implementations.įinally, the 3D Manager addresses EDID challenges that have previously made it difficult to distribute 3D content to multiple displays. How about a BIG issue with traditional 3D: Crosstalk. 60Hz means breaking the video down to about 30 frames per second for each eye, which is much easier on the eyes. My eyes seemed to adjust much faster and more comfortably with the lower range.Īlso, overall comfort was much better. Personally I found a couple of reasons why 60Hz may be better than the higher rates, starting with adjustment times. I think 120Hz and 240Hz may have met their match when it comes to 3D. Not only did the 3D picture look great on some “old fashioned” HDTV sets shown at EHX, but the underlying technology had some nice surprises.įirst, Just Add Power demonstrated its solution using the 60Hz frequency. These active shutter LCD glasses work in conjunction with the Synch Nodes and Emitters. “We have already gathered that the Atlona switches will work for sure,” says Qualls. However, a standard switcher may be utilized instead. These pass-through devices, based on Just Add Power’s HDMI-over-IP technology, are needed for each room that wants the benefit of 3D video. Using the RS-232 interface, the custom installer is able to dynamically control various functions such as frequency (60Hz/120Hz), scaling, color processing, noise reduction and EDID response.
HDTV 2D TO 3D CONVERSION 720P
This pass-through device converts the 3D source content to a 1080p or 720p signal compatible with practically any existing HDTV or projector. The 3D Manager includes these three pieces:
HDTV 2D TO 3D CONVERSION FULL
The 3D Manager works with the full range of 3D broadcast standards (frame packing, side-by-side, top-and-bottom) to deliver a frame-sequential 3D experience with the matching 3D Glasses. But most households have only one or two (or zero) 3D-capable displays in the house. As described, the technology could potentially save consumers thousands of dollars, protecting their initial investment and making the integrator look like a star.īut I was skeptical … until I experienced the 3D Manager at the show.Ĭonsumers currently have access to multiple 3D sources including Blu-ray, satellite, PS3, Vudu, cable and others. I interviewed Just Add Power principal Ed Qualls before EHX 2011 and the solution sounded pretty good. The new solution, introduced at the Electronic House Expo (EHX) last week, turns virtually any HDTV with an HDMI port into a 3D-enabled display.
Instead, you might want to check out the 3D Manager from Just Add Power, one of the original developers of HDMI-over-IP. If you’re thinking about trashing your old legacy HDTV sets just to get a 3D picture … think again.
0 kommentar(er)
